BIONIME GM550 Bedienungsanleitung PDF herunterladen (Seite 22)

Sampling Error

Please don't apply the blood drop to the sample entry of the strip before the

meter displays . If you do so, the meter will display " " and " "

accompanied by beeps (if volume is turned on). Please discard the test strip and

repeat the test with a new teststrip.

" "

Meter Malfunction

If the meter can not be started, please follow the steps below:

1. Open the battery cover, remove the batteries.

2. Wait for 5 minutes and insert the batteries as described “Meter activation and Battery change”

on page 16~17.

The meter should be working normally after finishing above steps. If not, please contact your local

Bionime customer service.

Temperature Error

In order to get accurate test result, perform testing between 10~40℃ ( 50~104℉ ).

1. When the ambient temperature is 0~9℃ ( 32~48℉) or 41~50℃ (106~122℉)

the " " warning symbol will be blinking (1a), you still can do the test but the test

result is only for reference, because the test result under these ranges of

temperature might not be correct. In the memory screen this value will be flagged

with symbol (1b). Repeat the test at an area with temperature between

operating range. ( 10~40℃ or 50~104℉ )

2. When you move from the area with temperature outside the operating range of

test strip to another area with temperature inside operating range of test strip,

please wait for 30 minutes before you do the test.

3. When the temperature is below 0℃ ( 32℉ ) or over 50℃ ( 122℉ ), Meter can not

do the test and the " " symbol will blink with thermograph symbol displaying

on screen in this condition. Please move the meter to environment with

temperature between 10~40℃ ( 50~104℉ ) and repeat the test after 30 minutes.

" "

Code Error

It means the strip is not inserted right or to the proper position. Please reinsert the

strip following the instruction. If Code Error repeats again, it means you use wrong

strip or strip not suitable for your region test. After you make sure you use the right

strip and the strip is inserted right, but error screen still appears, please contact

your local Bionime Customer Service.

Error messages and Trouble shootingError messages and Trouble shooting

1 2 ... 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

BIONIME GM550 Bedienungsanleitung Seite 22